Filter
Top Products
2-58
SET ATM NEIGHBOR IP_ADDRESS
SET ATM NEIGHBOR
IP_ADDRESS
Use the SET ATM NEIGHBOR IP_ADDRESS command to specify an IP address for
the peer ATM device to which SNMP requests on UDP port 161 may be
directed.
Normally, this value is provided automatically by the peer through the Interim
Local Management Interface (ILMI). However, if the peer’s ILMI does not provide
this value, you can use this command to configure the value for network
management purposes.
The peer IP address is advertised in the ATM Backbone SwitchModule’s RFC1695
ATM MIB.
The ATM NEIGHBOR IP address is four decimal numbers separated by periods.
Each number can range from 0 to 255. However, the following addresses are
illegal:
■
0.0.0.0
■
255.255.255.255
Format
Example
The following command sets the neighbor ip_address for the peer ATM device
in slot 4 to 02.04.80.20:
CB5000> set atm 4 neighbor ip_address 02.04.80.20
Slot 04 parameter set.
Related Command
SHOW ATM INTERFACE
slot Identifies the slot for this operation.
slot (1 through 17) is the slot number.
option Use 4 decimal numbers separated by periods for the IP address.
set atm
neighbor
slot
ip_address
option