Filter
Top Products
2-184
SET PORT MODE
SET PORT MODE
Use the SET PORT MODE command to turn ports on or off.
Format
Example
The following command disables (turns off) port 2 on the module in slot 6:
CB5000> set port 6.2 mode disable
Port 06.02 set to DISABLED.
Related Commands
SET PORT NETWORK
SHOW PORT
slot.
all
set port mode
disable
enable
slot.port
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number location of a module in the hub
and port (1 through 40) is the port number on the specified module.
For example, to identify port 4 on the module in slot 6, enter
6.4
slot.
all
Specifies that all ports on the module are affected by this operation.
disable
Disables the identified port.
enable
Enables the identified port.
The factory setting is all ports enabled.