Filter
Top Products
2-68
SET BOOTP MODULE
SET BOOTP MODULE
Use the SET BOOTP MODULE command to specify an NMC (or A-ENMC
interface) to use as the BootP interface. BootP (Bootstrap Protocol) is a
UDP/IP-based protocol (User Datagram Protocol/Internet Protocol) that allows a
device to configure itself dynamically without user intervention. This command
applies to the DMM and the Advanced DMM/Controller modules.
Format
Example
The following command specifies slot 5, subslot 1 as the BootP interface:
CB5000> set bootp module 5.1
Related Commands
CLEAR BOOTP
SET BOOTP POWER_UP_MODE
SET BOOTP SERVER_IP_ADDRESS
SHOW BOOTP
slot.subslot slot
is the slot number in the hub. subslot
is the subslot on the
module in the specified slot. For example, to identify subslot 4 of slot
6, enter
6.4
set bootp module
slot.subslot