Filter
Top Products
CLEAR SECURITY PORT
2-27
CLEAR SECURITY
PORT
Use the CLEAR SECURITY PORT command to remove a MAC address from the
security database for a port.
To remove all old MAC addresses from the Autolearning database, you must
clear both the Autolearn Address table using the CLEAR SECURITY AUTOLEARN
slot.ALL MAC_ADDRESS command and then clear the Security Address database
using the CLEAR SECURITY PORT slot.ALL MAC_ADDRESS command.
Removing an authorized MAC address does not automatically disable Security
Mode. If you remove the only authorized MAC addresses for a port but do not
disable Security Mode, the DMM prevents any station from communicating
through the port.
Use the SET SECURITY PORT MODE command to enable and disable Security
Mode.
Format
Example
The following command clears the MAC address 07-34-24-02-0F-00 from the
security database for all ports on the module in slot 7:
CB5000> clear security port 7.all mac_address 07-34-24-02-0F-00
Port 07.all security MAC address 07-34-24—02-0F-00 cleared.
Related Commands
REVERT/SAVE SECURITY
SET SECURITY PORT ACTION_ON_INTRUSION
SET SECURITY PORT MAC_ADDRESS
SET SECURITY PORT MODE
SHOW SECURITY PORT
slot.port Removes the MAC address from the security database for the port
identified by slot.port.
slot is the slot number and port is the port number. For example, to
identify port 4 on the module in slot 6, enter
6.4
slot.
all
Removes the MAC address from the security database for all ports in
the identified slot.
all
Removes all MAC addresses from the security database for the entire
hub.
mac address Removes the MAC address from the security database for the
identified port. Enter the address as a series of six hexadecimal bytes
separated by hyphens. For example, 10-00-f1-0f-0c-63.
clear security port
slot.port
mac_address
mac address
all
slot.
all
all