Filter
Top Products
SHOW INTERFACE
2-341
SHOW INTERFACE
Use the SHOW INTERFACE command to display the location and status of DMM
network interfaces (through NMCs). Only interfaces actually allocated (as
compared to potential installed networks) are displayed. A hub can have up to
45 interfaces.
Format
Example
The following command displays the status and location of DMM network
interfaces:
CB5000>
show interface
Admin Oper MAC General
Idx Network Type Stat Stat Address Slot Information
---- ----------- ------ ----- ----- ------- ---- ----------
2 SLIP SLIP DOWN DOWN N/A N/A
3 ETHERNET_1 ETH UP UP 67-4b-0e-63-7a-f9 02.01.01
4 VBRIDGE 1 VB UP UP 08-00-8f-20-e5-f8 17.01.01
Related Command
SET MODULE INTERFACE
show interface
Field Description
Idx Interface index. Several commands use this index to identify a particular
interface.
Network Network interface described on the current line.
Type ETH (Ethernet), TR (Token Ring), or SLIP (Serial Line Interface Protocol), or
VB (Vbridge).
Admin Stat Setting applied to this network using the SET MODULE INTERFACE
command.
Oper Stat Operating status of the network interface.
MAC Address MAC address of the interface used to attach to this network.
Slot The slot and subslot location of the interface in the hub. For NMCs, this
field also identifies the interface. For example, 03.02.01 identifies slot 3,
subslot 2, interface 1. For Vbridges, it identifies the IP relay port. For
example, 07.01.01 identifies slot 7, subslot 1, port 1.
General
Information
If interface is in:
■
Standby (NMC only) — The NMC is an extra card placed in the hub
for redundancy.
■
Module Down — The module for this interface is down.
■
Interface Disabled — The interface is disabled.