Filter
Top Products
. . . . .
MEMORY CONTROLLER
StaticMemory Configuration 0–3 registers
www.digiembedded.com 251
The Dynamic Memory RAS and CAS Delay 0–3 registers allow you to program the RAS
and CAS latencies for the relevant dynamic memory. It is recommended that these
registers be modified during system initialization, or when there are no current or
outstanding transactions. Wait until the memory controller is idle, then enter low-
power or disabled mode.
Note:
The values programmed into these registers must be consistent with the
values used to initialize the SDRAM memory device.
Register
Register bit
assignment
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
StaticMemory Configuration 0–3 registers
Address: A070 0200 / 0220 / 0240 / 0260
The Static Memory Configuration 0–3 registers configure the static memory
configuration. It is recommended that these registers be modified during system
initialization, or when there are no current or outstanding transactions. Wait until
the memory controller is idle, then enter low-power or disabled mode.
13121110987654321015 14
31 29 28 27 26 25 24 23 22 21 20 19 18 17 1630
Reserved
Reserved CAS
Reserved RAS
Bits Access Mnemonic Description
D31:10 N/A Reserved N/A (do not modify)
D09:08 R/W CAS CAS latency
00 Reserved
01 One clock cycle, where the RAS to CAS latency (RAS) and
CAS latency (CAS) are defined in
clk_out cycles
10 Two clock cycles
11 Three clock cycles (reset value on
reset_n)
D07:02 N/A Reserved N/A (do not modify)
D01:00 R/W RAS RAS latency (active to read/write delay)
00 Reserved
01 One clock cycle, where the RAS to CAS latency (RAS) and
CAS latency (CAS) are defined in
clk_out cycles
10 Two clock cycles
11 Three clock cycles (reset value on
reset_n)