Filter
Top Products
120 Basic network printing setup ENWW
Basic network printing setup
The procedures to set up basic network printing vary depending on the configuration of the
network. The following is an overview of the basic approach for a TCP/IP network where
automatic IP configuration is not available:
1 Connect a network cable to the HP Jetdirect print server RJ-45 connector on the back
of the MFP, and then turn the MFP on.
2 Several networks have DHCP, BOOTP, or similar TCP/IP services that provide an IP
address and additional information such as a default gateway and subnet mask after
the MFP is connected to the network. If your network has one of these services, then
no more configuration on the MFP is required.
If a service such as DHCP or BOOTP is not available on the network, your network
administrator will have to assign an IP address and other information to the MFP. This
can be accomplished in several ways, but the easiest is to specify the information by
using the control panel menus.
3 Open the menus by pressing the M
ENU button.
4 Scroll to and touch C
ONFIGURE DEVICE.
5 Touch I/O.
6 Touch E
IO 1 JETDIRECT.
7 Touch T
CP/IP.
8 Touch C
ONFIG METHOD.
9 Touch S
ELECT MANUAL. (The message SETTING SAVED appears on the control-panel
display.)
10 Touch M
ANUAL SETTINGS when it appears on the control-panel display.
MENU
button