Filter
Top Products
228 Managing supplies ENWW
Replacing the image cleaning kit
Use this procedure to install the image cleaning kit.
1 Replace the cleaning kit when REPLACE CLEANING KIT
appears on the control-panel display.
2 Remove the new parts from the packaging and save the
packaging. If a finishing device is installed on the left side of
the MFP, pull it away from the MFP.
3 On the left side of the MFP, use the blue tab on the rear edge
of the MFP to pull the filter out of the slot.
4 Remove the new filter from its packaging and insert the filter
into the slot.
Note
Do not print without a filter installed.
5 Open the front doors.
6 Grasp the clear top of the toner collection bottle and pull the
bottle toward you, up, and out of the holder. Set the bottle
aside for recycling.
Note
If toner gets on your clothes or hands, wash them with cold water.
1
2
3
4
5
6