Filter
Top Products
240 Cleaning procedures ENWW
Cleaning the fuser input
Occasionally, toner and paper dust collects in the fuser input and
can affect print quality. Use the following procedure to clean the
fuser input.
1 Open the front doors of the MFP, and then swing the large
green lever down.
2 On the front side of the MFP, locate the blue transfer-roller
handle beneath the large green lever. Grasp the handle and
pull the roller out of the MFP. Set the roller on a clean, flat
surface.
CAUTION
Do not touch the black foam roller, and be careful not to scratch
the underside of the image transfer belt as you remove the roller
from the MFP.
3 Remove the green tongs and blue brush that are mounted on
the inside of the right front door.
4 Slide the open end of the brush onto the tongs until it snaps
into place.
5 Hold the tongs so that the brush is at a 45° angle and align
the brush with the transfer roller slot. Insert the brush into the
slot.
6 Slide the brush into the transfer roller slot until it stops, and
then slide the brush toward you until the brush is almost out of
the transfer roller slot.
CAUTION
Do not pull up or sideways on the brush. Push and pull the brush
straight in and out of the MFP.
7 Repeat step 6 three times, and then remove the brush from
the MFP.
1
2
3
4
5
6