Filter
Top Products
352 Checking the MFP configuration ENWW
PCL or PS font list
Use the font lists to see which fonts are currently installed in the MFP. (The font lists also
show which fonts are resident on a hard disk or flash DIMM.)
The PS font list shows the PS fonts installed, and gives a sample of those fonts.
The following describes the information that can be found on the PCL font list:
● Font gives the font names and samples.
● Pitch/Point describes the pitch and point size of the font.
● Escape Sequence (a PCL 5c programming command) is used to select the
designated font. (See the legend at the bottom of the font list page.)
● Font # is the number used to select fonts from the MFP control panel (not the software
program). Do not confuse the font # with the font ID, which is described below. The
number indicates the DIMM slot where the font is stored.
• SOFT: Downloaded fonts that stay resident in the MFP until other fonts are
downloaded to replace them or until the MFP is turned off.
• INTERNAL: Fonts that reside permanently in the MFP.
● Font ID is the number you assign to soft fonts when you download them to the MFP
through the font download utility.
To print a PCL or PS font list page
1 Press the MENU button.
2 Touch I
NFORMATION.
3 Touch P
RINT PCL FONT LIST or PRINT PS FONT LIST.