Filter
Top Products
24 Loading input trays ENWW
To load undetectable standard-size media in tray 2
and tray 3
Use this procedure to load undetectable standard-size media in
the tray. The following are the undetectable sizes, which are
marked inside the tray:
● 8K
● 16K
● A5
● Statement
● Executive
● 8.5 x 13 (216 x 330 mm)
CAUTION
To avoid a jam, never add or remove media from a tray while
printing from that tray.
1 Pull the tray open until it stops.
2 Press the tab on the front (X) paper guide and slide the guide
all the way out.
3 Press the tab on the left (Y) paper guide and slide the guide
all the way out.
4 Load (orient) the media according to size.
Note
For more information about how to orient the media size that you
are using, see “Orienting media” on page 168.
5 Adjust the left (Y) media guide by pressing the tab on the
guide and slide the guide until it gently touches the paper.
6 Adjust the front (X) media guide by pressing tab on the guide
and slide the guide until it gently touches the paper.
7 Set the Custom/Standard switch to Custom.
8 Slide the tray into the MFP.
9 Look at the control panel within a few seconds of closing the
tray. (Open and close the tray if the time has already
elapsed.) The control panel displays the tray size and type
configuration. Do one of the following:
● If the size and type settings are correct, touch EXIT to accept
the settings.
● If the size and type settings are not correct, touch OK. The
TRAY N SIZE=*<SIZE> menu is displayed.
10 To change the size setting, touch the correct paper size. The
message SETTING SAVED is displayed for a moment, and then
the tray type menu is displayed.
6
1
4
5
8
7