Filter
Top Products
378 ENWW
Preparing a location for the MFP
1 Place the multifunction printer (MFP) in a well-ventilated area
that does not expose the MFP to chemicals, including
ammonia, or sunlight. Hewlett-Packard recommends
maintaining the MFP’s environment within a temperature
range of 20°C to 26°C (68°F to 79°F) and a relative humidity
range of 20% to 50%.
2 Determine the correct voltage for your MFP by checking the
voltage rating (shown on a label on the MFP inside the right
front door). The MFP requires either a dedicated 15-amp,
100-volt to 127-volt circuit or a dedicated 10-amp, 220-volt to
240-volt circuit.
3 Place the MFP, finishing device, and 2,000-sheet side input
tray (tray 4) on a sturdy, level surface (side view shown). Make
sure that sufficient space exists around the MFP so that the
air vents on the left side, right side, and back of the MFP are
not blocked.
4 Make sure that sufficient space is available on the left side of
the finishing device and on the right side of the 2,000-sheet
side input tray (tray 4) to allow access to clear jams (top view
shown).
Note
The maximum height of the MFP is 1,651 mm (65 inches), the
maximum width is 1,080 mm (42.5 inches), and the maximum
length is 2,660 mm (104.7 inches).
2
3
4
1