Filter
Top Products
ENWW 6 Control-panel menus 143
PERSONALITY *AUTO
PCL
PDF
XHTML
MIME
PS
Use this item to select the default printing
language (personality). Possible values
are determined by which valid languages
are installed in the MFP.
Usually, you should not change the
product language (the default is AUTO). If
you change it to a specific product
language, the MFP does not
automatically switch from one language
to another unless it receives specific
software commands.
CLEARABLE WARNINGS *JOB
ON
Use this item to set the amount of time
that a clearable warning appears on the
control panel.
ON: Warning messages appear on the
control panel until C
ONTINUE is touched.
JOB: Warning messages appear on the
control panel until the end of the job from
which they were generated.
AUTO CONTINUE *ON
OFF
Determine how the MFP reacts to errors.
ON: If an error prevents printing, the
message appears and the MFP goes
offline for 10 seconds before returning
online.
OFF: If an error prevents printing, the
message continues to appear and the
MFP does not print until C
ONTINUE is
touched.
Note
To stop printing when the MFP is out of
staples, set AUTO CONTINUE=OFF on the
control-panel System setup menu.
SUPPLIES LOW *CONTINUE
STOP
Use this item to determine how the MFP
functions when toner is low. The
CARTRIDGE LOW message appears when
the print cartridge is almost out of toner.
(After the message appears, about 2,400
pages can still be printed at 5%
coverage.)
CONTINUE: The MFP continues to print
while the CARTRIDGE LOW message
appears.
STOP: The MFP goes offline and wait for
further action.
For more information, see “Managing
supplies” on page 210.
COLOR SUPPLY OUT *STOP
AUTOCONTINUE BLACK
Use this item to set the MFP behavior
when a color supply runs out.
Item Values Explanation