Filter
Top Products
ENWW 10 Problem solving 269
Clearing jams from the duplexer
Jam inside the duplexer
Follow these instructions to clear jams in the duplexer.
1 Move the finishing device away from the MFP to gain access
to the lower left door. To do this, stand on the left side of the
MFP and pull the finishing device straight toward you.
CAUTION
Do not push the finishing device face-up tray when you are
removing or installing the finishing device.
2 Open the lower left door.
WARNING!
Avoid touching the fusing area above the duplexer. It can be hot.
3 Remove the duplexer by pressing the green lever down and
pulling the unit out until it stops.
4 Remove the duplexer completely.
5 Lift the two green levers in the duplexer and remove any
media that is underneath.
5
4
3
1
2