Filter
Top Products
ENWW 10 Problem solving 307
SANITIZING DISK FAILED The hard disk or the Flash Memory disk
sanitization failed.
Turn the MFP and then back on.
SCAN CARRIAGE LOCKED
CHECK LOCK SWITCH, CYCLE
POWER
The flatbed scanner carriage is locked
for shipping.
1 Turn off the MFP.
2 Unlock the scanner carriage. See
“Before you move the MFP” on
page 253 for more a graphic of this
step.
3 Turn on the MFP.
SCANNING The MFP is scanning a job. No action is necessary.
SCANNING IMAGE The MFP is scanning an image. No action is necessary.
SCANNING PAGE [X} The MFP is scanning a job. No action is necessary.
SCANNING PAGE FROM GLASS The MFP is scanning a page from the
glass.
No action is necessary.
SIZE MISMATCH IN TRAY XX Tray X is loaded with media that is longer
or shorter in the feed direction than the
size that is configured for the tray.
Reconfigure the tray or move the media
to a tray that is configured for that size.
SLEEP MODE ON The MFP is in power save mode. Press any button to exit power save
mode.
STAPLER OPTION NO LONGER
AVAILABLE.
A staple command was selected in
addition to a command that is not
compatible with a staple command.
No action is necessary if stapling is not
required.
If you want to staple, select another
staple option or deselect the command
that is not compatible with a staple
command.
STAPLER LOW
ON STAPLES
The stapler device is running out of
staples.
Printing will continue until the staple
cartridge is empty. Order a new staple
cartridge.
STAPLER OUT OF
STAPLES
TO CONTINUE TOUCH OK
The stapler device is out of staples and
needs to be refilled.
Replace the stapler cartridge.
Touc h O
K to continue printing without
stapling.
TESTING...
PLEASE WAIT
The MFP is performing a test. No action is necessary.
THE BOOKLET ACCESSORY IS
LIMITED TO THE FOLLOWING
PAPER SIZES: LETTER-R,
LEGAL, LEDGER, A4-R, A3,
B4 (JIS)
The MFP can only make booklets that
contain pages of the indicated media
sizes.
Use a supported media size for making
booklets.
THE DIGITAL SENDER IS
CURRENTLY PROCESSING THE
MAXIMUM NUMBER OF ACTIVE
JOBS ALLOWED.
PLEASE TRY TO SEND YOUR
JOB LATER.
The digital sender is processing the
maximum number of jobs.
Wait and then try sending your job
again.
Message Description or explanation Recommended action