Filter
Top Products
202 Using the MFP memory ENWW
Checking memory installation
Follow this procedure to verify that Flash Memory cards are installed correctly:
1 Make sure that READY appears on the MFP control-panel display when the MFP is
turned on. If an error message appears, a Flash Memory card might have been
incorrectly installed.
2 Print a configuration page. See “Checking the MFP configuration” on page 344 for
instructions to print a configuration page.
3 Check the memory section on the configuration page and compare it to the
configuration page that you printed before installing the Flash Memory card. If the
amount of memory has not increased, one of the following situations might have
occurred:
• The Flash Memory card might not be installed correctly. Repeat the installation
procedure.
• The Flash Memory card might be defective. Try a new Flash Memory card, or try
installing the Flash Memory card in a different slot.
Note If you installed a printer language (personality), check the Installed Personalities and
Options section on the configuration page. This area should list the new printer language.