Filter
Top Products
ENWW 9 Managing and maintaining 241
8 Remove the brush from the tongs by raising the snap on the
back of the brush and pulling the brush away from the tongs.
9 Replace the tongs and brush on the inside of the right door.
10 Using one hand to support the underside of the transfer roller,
turn the roller to a 45° angle and align the roller with the slot.
Slide the roller into the slot until it stops.
CAUTION
Do not touch the black foam roller, and be careful not to scratch
the underside of the image transfer belt as you insert the roller
into the MFP.
11 Swing the green lever up, and then close the front doors.
Note
If the lever does not move freely, make sure that the transfer roller
is pushed into the MFP completely. See also “MFP hardware
issues” on page 331.
8
10
11