Filter
Top Products
22 Loading input trays ENWW
Loading tray 2 and tray 3
Tray 2 and tray 3 hold up to 500 sheets of standard media.
To load detectable standard-size media in tray 2
and tray 3
Use this procedure to load detectable standard-size media in the
tray. The following are the detectable sizes, which are marked
inside the tray:
● A4
● Letter
● A3
● Legal
● Executive
● 11 x 17
● B4
● B5
● A4-R
● Letter-R
CAUTION
To avoid a jam, never add or remove media from a tray while
printing from that tray.
1 Pull the tray open until it stops.
2 Adjust the left (Y) media guide by pressing the tab on the
guide and set the guide to the correct media size.
3 Adjust the front (X) media guide by pressing the tab on the
guide and set the guide to the correct media size.
4 Load (orient) the media according to size.
CAUTION
Do not load more media than the maximum that is indicated by
the media-fill triangles at the back of the tray.
5 Set the custom/standard switch to Standard.
6 Slide the tray into the MFP.
7 Look at the control panel within a few seconds of closing the
tray. (Open and close the tray if the time has already
elapsed.) The control panel displays the tray size and type
configuration. Do one of the following.
● If the size and type settings are correct, touch EXIT to accept
the settings.
4
1
2
3
6
5