Filter
Top Products
ENWW D Setting up the MFP 381
13 Position the new overlay over the control panel (16). Align the
ends of the overlay with the holes on the control panel and
slide the overlay in. Snap the overlay firmly onto the control
panel. Make sure that the overlay is flat against the control
panel. Repeat this step to change the second overlay.
14 Remove the orange tape from tray 1.
15 Remove the orange tape from the front doors.
16 Open the front doors, and swing the large, green lever down.
17 Rotate the blue dial up until it clicks and the image-drum door
unlatches, and then open the image-drum door (17)
completely.
18 Remove the four pieces of foam and remove the orange tape.
Close the image-drum door, pressing the tabs at the top of
the door until they click into place.
14
15
16
17
13
18
16
16
17