Filter
Top Products
ENWW 6 Control-panel menus 147
TCP/IP ENABLE
HOST NAME
CONFIG METHOD
DHCP RELEASE
DHCP RENEW
MANUAL SETTINGS
ON
OFF
BOOTP
DHCP
AUTO IP
MANUAL
NO
YES
NO
YES
IP ADDRESS
N.N.N.N
SUBNET MASK
M.M.M.M
SYSLOG SERVER
N.N.N.N
DEFAULT
GATEWAY
N.N.N.N
IDLE TIMEOUT
XX
Use this item to specify whether the
TCP/IP protocol is enabled (ON) or
disabled (OFF).
Use this item to specify an
alphanumeric string up to 32
characters. The default host name is
NPIXXXXXX, where XXXXXX is the last
six digits of the LAN hardware (MAC)
address.
Use this item to specify whether the
TCP/IP configuration parameters are
set automatically from a network
server by using BootP (Bootstrap
Protocol), DHCP (Dynamic Host
Configuration Protocol), Auto IP, or
manually from the EIO submenu.
This item appears if the Config
Method is set to DHCP and a DHCP
lease for the print server exists.
This item appears if Config Method
is set to DHCP and a DHCP lease for
the print server exists.
Use this item to provide access to
parameters that can be manually
configured from the control panel.
For manual configuration, CONFIG
METHOD must be set to MANUAL.
The value represents the unique IP
address of the MFP, where N is a
value from 0 to 255.
The value represents the subnet
mask for the MFP, where M is a value
from 0 to 255. The mask is applied to
IP addresses to identify subnetworks
and modes uniquely.
The value represents the IP address
of the syslog server that is used to
receive and log syslog messages.
The value represents the IP address
of the gateway or router used for
communications with other networks.
The value represents the timeout
value (in seconds) after an idle TCP
print data connection is automatically
closed. The default value is 270
seconds, and 0 disables the timeout.
Item Options Values Explanation