Filter
Top Products
ENWW 8 Selecting and using media 171
Prepunched letter or A4
(weights up to
200 g/m
2
) (53-lb bond).
Note
If you are using
prepunched media that
is also preprinted, set
the type to P
REPRINTED.
2 or 3 Yes Long edge with holes toward the right side of the
tray; top of page toward the front of the tray; side
to be printed on facing up.
Prepunched custom
size or alternative
method for prepunched
letter or A4
(weights up to
200 g/m
2
) (53-lb bond).
Note
For custom-size
prepunched media, or if
other orientations for
letter and A4
prepunched media are
not aligned properly
(holes on wrong side),
use this orientation. The
MFP prints at half
speed in this
orientation.
2 or 3 Yes Long edge with holes toward the front of the
tray; top of page toward the right side of the tray;
first side to be printed on facing down.
Labels (letter- or A4-
size sheets) or
transparencies.
Tray 1
only
No
(never
duplex)
Long edge toward the MFP; top of page toward
the rear of the MFP; side to be printed on facing
up.
Envelopes. Tray 1
only
No
(never
duplex)
Short edge toward the MFP (stamp edge away
from the MFP); side to be printed on facing up. If
the height of the envelope is greater than 8.25
inches, feed the envelope with the flap edge
toward the MFP. Otherwise, feed the envelope
with the flap edge toward the rear of MFP.
Standard letter/A4. 2,000-
sheet side
input tray
(tray 4)
No Long edge toward the MFP; first side to be
printed on facing up.
Note
For letter-R or A4-R, the media can be loaded
with the short edge toward the MFP. This is
required when printing letter or A4 booklets
using the multifunction finisher.
Standard letter/A4. 2,000-
sheet side
input tray
(tray 4)
Yes Long edge toward the MFP; first side to be
printed on facing down.
Note
For letter-R or A4-R, the media can be loaded
with the short edge toward the MFP. This is
required when printing letter or A4 booklets
using the multifunction finisher.
Table 1. Orienting media
Media Tray Duplex Orientation