Filter
Top Products
ENWW 10 Problem solving 271
Clearing jams from the output areas
Jam in the fuser area at the lower left door
Follow these directions to clear jams at the lower left door (fuser
area).
1 Move the finishing device away from the MFP to gain access
to the lower left door. To do this, stand on the left side of the
MFP and pull the finishing device straight toward you.
2 Open the upper left door.
3 If the jammed media is visible, remove it from the MFP. Then
close the upper left door and continue printing. If the jammed
media is not visible, go to step 4.
4 Open the lower left door.
WARNING!
Avoid touching the adjacent fusing area. It can be hot.
5 Lift the green tabs and remove any jammed or damaged
media. Be sure to remove all of the pieces of torn media.
1
2
4
3
5