Filter
Top Products
ENWW 1 MFP basics 31
Loading the staple cartridge (multifunction finisher)
Use this procedure to load staples in the multifunction finisher.
The message STAPLER LOW ON STAPLES appears on the control panel if the staple cartridge
has 20 to 50 staples remaining. The message STAPLER OUT OF STAPLES appears on the
control panel if the stapler cartridge contains no more staples.
To load the staple cartridge
1 Open the stapler-unit door.
2 Slide the stapler unit toward you.
3 Turn the large, green knob until you see the blue dot (this
indicates that the stapler is fully open).
4 Turn the small, green knob at the top of the stapler unit
clockwise until the staple cartridge moves to the left of the
stapler unit.
CAUTION
The blue dot must appear in the window of the stapler unit before
you remove the staple cartridge. If you try to remove the staple
cartridge before the blue dot appears in the window, you could
damage the finishing device.
1
4
2
3