Filter
Top Products
ENWW 9 Managing and maintaining 225
19 In tray 3, locate the small roller and two large rollers to the
right inside the opening.
20 Pinch the plastic tab on the end of each roller to remove the
roller. Remove all three rollers.
21 Grasp each new roller by both sides and slide it onto the
corresponding rod until the roller clicks into place. Replace
the tray 2 rollers by using steps 18 through 20.
Note
Make sure that the small roller is to the left in both trays.
22 Align tray 2 with the rails inside the MFP, and then slide the
tray into the MFP. Align tray 3 with the rails inside the MFP,
and then slide the tray into the MFP.
23 Remove all of the media from the 2,000-sheet side input tray
(tray 4).
24 Locate the three large rollers inside the opening.
20
21
22
23
24
19