Filter
Top Products
380 ENWW
7 Make sure that the wheel locks (11) are in the unlocked
position and then roll the MFP onto the unloading ramps and
off of the pallet (12).
CAUTION
The MFP is heavy. Hewlett-Packard recommends that two people
roll the MFP off of the pallet.
8 Remove the orange tape from tray 2 and tray 3.
9 Remove the tray locks and orange tape from tray 2 and tray 3.
10 Open the automatic document feeder (ADF) access door,
remove the foam pad and orange tape, and then close the
ADF access door.
11 Remove the orange tape on the ADF, open the ADF, and then
remove the foam and orange tape from inside the ADF.
Note
If you want to change the control-panel-overlay language, perform
the following steps. If the control-panel overlays are not installed,
begin with step 13.
12 Locate the two-control panel overlays (13). Insert a small, flat-
blade screwdriver or another thin, narrow device in the slot at
the top edge of one of the overlays (14). Lift the overlay up
and backward to move it away from the MFP (15). Repeat 14
and 15 for the second overlay.
8
9
10
11
7
12
11
12
13
13
14
15
15