Filter
Top Products
ENWW 6 Control-panel menus 149
Resets submenu
Note Be careful when using this menu. You can lose buffered page data or MFP configuration
settings when you select these items. Reset the MFP with RESTORE FACTORY SETTINGS only
under the following circumstances:
● You want to restore the MFP default settings.
● Communication between the MFP and the computer is interrupted.
● You are having problems with a port.
The items in the Resets submenu clear memory in the MFP, while R
ESET clears only the
current job.
Item Explanation
RESTORE FACTORY SETTINGS Select this item to perform a simple reset and restore most of the
factory (default) settings. This item also clears the input buffer for
the active I/O. The e-mail gateways are not changed, and the local
address book is not cleared.
Resetting memory during a print job can result in data loss.
CHARGER CLEANED Use this item to verify that the post charger was cleaned.
SLEEP MODE Use this item to turn SLEEP MODE on and off. If SLEEP MODE is off,
the MFP never enters sleep mode and no asterisk appears next to
any item when you open the SLEEP DELAY menu item. The values
for SLEEP MODE are ON, OFF, LOW, and HIGH, and the default value is
ON. When the MFP is in SLEEP MODE, the display backlight is turned
off and the message SLEEP ON appears on the control-panel
display.
LOCK CARRIAGE Use this item to move the scan head into the locked position
before turning the MFP off and before you transport the MFP.
See “Before you move the MFP” on page 253 for more
information on how to employ the mechanical scan head lock and
additional steps to use when moving the MFP.
CLEAR ADDRESS BOOK Use this item to remove all entries in the local address book.
RESET SUPPLIES Use this item to indicate that a new supply (consumable) has been
installed in the MFP.