Filter
Top Products
314 Understanding MFP messages ENWW
57.XY
TO CONTINUE TURN OFF THEN
ON
A temporary printing error has occurred. 1 Turn the MFP off, and then turn the
MFP on. Check to see if the
message goes away.
2 Check the fans for obstructions.
3 If this message persists, contact an
HP-authorized service or support
provider. (See “Information from the
MFP” on page 363, or go to
www.hp.com/go/clj9500mfp
.)
58.X
TO CONTINUE TURN OFF THEN
ON
A temporary printing error has occurred. 1 Turn the MFP off, and then turn the
MFP on. Check to see if the
message goes away.
2 Reseat the print cartridges and the
image drums.
3 If this message persists, contact an
HP-authorized service or support
provider. (See “Information from the
MFP” on page 363, or go to
www.hp.com/go/clj9500mfp
.)
59.X
TO CONTINUE TURN OFF THEN
ON
A temporary printing (motor) error has
occurred.
1 Turn the MFP off, and then turn the
MFP on. Check to see if the
message goes away.
2 If turning the MFP off and on does
not resolve the 59.00 or 59.A0 error,
remove and reinstall the image
transfer cleaner.
3 Reseat the print cartridges and the
image drums.
4 If this message persists, contact an
HP-authorized service or support
provider. (See “Information from the
MFP” on page 363, or go to
www.hp.com/go/clj9500mfp
.)
60.X An obstruction prevents the tray
specified by
X from lifting media
correctly for feeding.
If this message persists, contact an
HP-authorized service or support
provider. (See “Information from the
MFP” on page 363, or go to
www.hp.com/go/clj9500mfp
.)
62
TO CONTINUE TURN OFF THEN
ON
No system was found. 1 Turn off the MFP.
2 Remove and reseat the hard-disk
EIO card.
3 Turn on the MFP.
4 If a firmware upgrade was
performed recently, download the
firmware again and perform the
upgrade again.
Note
Do not interrupt the upgrading process
by turning off the MFP or unplugging it.
Message Description or explanation Recommended action