Filter
Top Products
ENWW 9 Managing and maintaining 219
6 Remove the new drum from its packaging and save the
packaging.
CAUTION
Do not yet remove the protective slide cover on the underside of
the drum unit and do not touch the green component inside the
cartridge.
7 Place the drum on a level surface. Pull the orange ring on the
end to remove the seal (1). Pull the orange strip on top to
remove the protective sheet (2). Pull the two orange rings on
the side (3).
Note
Do not shake the drum.
8 Make sure that the four blue levers above the door are in the
horizontal position. Align the new drum with the empty slot,
arrow-end first. Rest the end of the drum flat on the door.
9 Hold the gray protective cover in place with one hand and
slide the drum into the MFP with the palm of your other hand.
Note
If the drum does not fit into the slot, make sure that you are
installing the correct color in the correct slot.
10 Repeat steps 5 through 9 for each cartridge that needs to be
replaced. Close the image-drum door, pressing the tabs at
the top of the door until they click into place.
6
8
10
7
9
1
2
3
3