Filter
Top Products
Hardware Reference Manual 269
Intel
®
IXP2800 Network Processor
Media and Switch Fabric Interface
If the next sequential element is not valid when its turn comes up:
1. Send an idle Control Word with SOP set to 0, and EOPS set to the values determined from the
most recently sent element, ADR field 0x00, correct parity.
2. Until an element becomes valid, send idle Control Words with SOP set to 0, EOPS set to 00,
ADR field 0x00, and correct parity.
Note: Sequential elements with same ADR are not “merged”, a Control Word is sent for each element.
Note: SPI-4 requires that all data transfers, except the last fragment (with EOP), be multiples of 16 bytes.
It is up to the software loading the TBUF element to enforce this rule.
After an element has been sent on the transmit pins, the valid bit for that element is cleared. The
Tx_Sequence register is incremented when the element has been transmitted; by also maintaining
a sequence number of elements that have been allocated (in software), the microcode can
determine how many elements are in-flight.
8.3.3.2 CSIX
Transmit control logic sends valid elements on the transmit pins in element order. Each element
sends a single CFrame. First the Base Header is sent — it is formed as shown in Table 101. Next,
the Extension Header is sent. Finally, the data is sent; the number of bytes to send is the total of
Element Control Word Prepend Length field plus the Element Control Word Payload Length, plus
padding to fill the final CWord if required (the CWord Size is programmed in
MSF_Tx_Control[Tx_CWord_Size]). Both Horizontal Parity and Vertical Parity are transmitted, as
described in Section 8.3.5.2.1 and Section 8.3.5.2.2.
Note: When transmitting a Flow Control CFrame, the entire payload must be written into the TBUF
entry. The extension header field of the Transmit Control Word is not used for Flow Control
CFrames.
Control elements and Data elements share use of the transmit pins. Each will alternately transmit a
valid element, if present.
If the next sequential element is not valid when its turn comes up, or if transmission is disabled by
FC_Ingress_Status[SF_CReady] or FC_Ingress_Status[SF_DReady], then transmit logic will
alternate sending Idle CFrames with Dead Cycles; it will continue to do so until a valid element is
ready. Idle CFrames get the value for the Ready Field from FC_Ingress_Status[TM_Cready] and
FC_Ingress_Status[TM_DReady], the Payload Length is set to 0.
Table 101. Transmit CSIX Header
CSIX Header Field Derived From
Type Type field of Element Control Word
Data Ready FC_Ingress_Status[TM_DReady]
Control Ready FC_Ingress_Status[TM_CReady]
Payload Length Element Control Word Prepend Length + Element Control Word Payload Length
P P Bit of Element Control Word
CR CR Bit of Element Control Word
Extension Header Extension Header field of Element Control Word