Filter
Top Products
Hardware Reference Manual 343
Intel
®
IXP2800 Network Processor
PCI Unit
9.4.1.4 DMA Channel Operation
Since a PCI device, Microengine, or the Intel XScale
®
core can access the internal CSRs and
memory in a similar way, the DMA channel operation description that follows will apply to all
channels. CHAN_1_, CHAN_2_, or CHAN_3_ can be placed before the name for the DMA
registers.
The DMA channel owner can either set up the descriptors in SRAM or it can write the first
descriptor directly to the DMA channel registers.
When descriptors and the descriptor list are in SRAM, the procedure is as follows:
1. The DMA channel owner writes the address of the first descriptor into the DMA Channel
Descriptor Pointer register (DESC_PTR).
2. The DMA channel owner writes the DMA Channel Control register (CONTROL) with
miscellaneous control information and also sets the channel enable bit (bit 0). The channel
initial descriptor bit (bit 4) in the CONTROL register must also be cleared to indicate that the
first descriptor is in SRAM.
3. Depending on the DMA channel number, the DMA channel reads the descriptor block into the
corresponding DMA registers, BYTE_COUNT, PCI_ADDR, DRAM_ADDR, and
DESC_PTR.
4. The DMA channel transfers the data until the byte count is exhausted, and then sets the
channel transfer done (bit 2) in the CONTROL register.
5. If the end of chain bit (bit 31) in the BYTE_COUNT register is clear, the channel checks the
Chain Pointer value. If the Chain Pointer value is not equal to 0. it reads the next descriptor
and transfers the data (step 3 and 4 above). IF the Chain Pointer value is equal to 0, it waits for
the Descriptor Added bit of the Channel Control register to be set before reading the next
descriptor and transfers the data (step 3 and 4 above). If bit 31 is set, the channel sets the
channel chain done bit (bit 7) in the CONTROL register and then stops.
6. Proceed to the Channel End Operation. (See Section 9.4.1.5.)
When single descriptors are written directly into the DMA channel registers, the procedure is as
follows:
1. The DMA channel owner writes the descriptor values directly into the DMA channel registers.
The end of chain bit (bit 31) in the BYTE_COUNT register must be set, and the value in the
DESC_PTR register is not used.
2. The DMA channel owner writes the base address of the DMA transfer into the PCI_ADDR to
specify the PCI starting address.
3. When the first descriptor is in the BYTE_COUNT register, the DRAM_ADDR register must
be written with the address of the data to be moved.
4. The DMA channel owner writes the CONTROL register with miscellaneous control
information, along with setting the channel enable bit (bit 0). The channel initial descriptor in
register bit (bit 4) in the CONTROL register must also be set to indicate that the first descriptor
is already in the channel descriptor registers.
5. The DMA channel transfers the data until the byte count is exhausted, and then sets the
channel transfer done bit (bit 2) in the CONTROL register.
6. Since the end of the chain bit (bit 31) in the BYTE_CONT register is set, the channel sets the
channel chain done bit (bit 7) in the CONTROL register and then stops.
7. Proceed to the Channel End Operation. (See Section 9.4.1.5.)