Filter
Top Products
155 | OSPFv2 DellPowerConnectW-SeriesArubaOS6.2 | User Guide
Branch Office Routing Table
View the branch office controller routing table using the show ip route command:
(host) #show ip route
Codes: C - connected, O - OSPF, R - RIP, S - static
M - mgmt, U - route usable, * - candidate default
Gateway of last resort is 20.1.1.2 to network 0.0.0.0
O* 30.0.0.0/0 [1/0] via 20.1.1.2*
C 14.1.1.0 is directly connected, VLAN14
C 15.1.1.0 is directly connected, VLAN15
C 20.1.1.0 is directly connected, Tunnel 1
The routing table of the Central office controller is below:
(host) #show ip route
Codes: C - connected, O - OSPF, R - RIP, S - static
M - mgmt, U - route usable, * - candidate default
Gateway of last resort is 4.1.1.2 to network 0.0.0.0
O* 0.0.0.0/0 [1/0] via 4.1.1.2*
O 14.1.1.0/24 [1/0] via 30.1.1.1*
O 15.1.1.0/24 [1/0] via 30.1.1.1*
C 4.1.1.0 is directly connected, VLAN4
C 5.1.1.0 is directly connected, VLAN5
C 20.1.1.0 is directly connected, Tunnel 1
The routing table for Router 1 is below:
(router1) #show ip route
Codes: C - connected, O - OSPF, R - RIP, S - static
M - mgmt, U - route usable, * - candidate default
O 14.1.1.0/24 [1/0] via 4.1.1.1
O 15.1.1.0/24 [1/0] via 4.1.1.1
C 4.1.1.0 is directly connected, VLAN4
The routing table Router 2 is below:
(router2) #show ip route
Codes: C - connected, O - OSPF, R - RIP, S - static
M - mgmt, U - route usable, * - candidate default
O 14.1.1.0/24 [1/0] via 5.1.1.1
O 15.1.1.0/24 [1/0] via 5.1.1.1
C 5.1.1.0 is directly connected, VLAN5
Configuring OSPF
Configure general OSPF settings from the OSPF tab on the Configuration >IP page (see Figure 42). The Area and
Excluded subnets are displayed in table format. If not explicitly specified for OSPF, the router ID defaults to the
switch IP.