Filter
Top Products
Figure 341: show dialer group example
The ATD, in the Dial String column in Figure 341, specifies the number to dial, and is typically the same among
respective CDMA/GSM carriers. The information under the Init String column typically just resets the modem to
the factory default state, but may contain carrier specific options. You can often find these settings in online forums
or from your ISP.
Linux Support
The Internet is a great place to research Linux support for your modem. Chances are someone already got it working
on their system and their configuration can be leveraged. The following sites provide useful information:
l http://www.evdoforums.com/
l http://ubuntuforums.org
l http://www.linux.com/forums
l http://kenkinder.com/
Setting Up NAS (Network-Attached Storage) Devices
The W-600 Series controller allows you to connect a pre-formatted NAS device that can be made available to all
connected clients. The W-600 Series supports NAS devices with partitions in filesystem formats:
l ext2
l ext3
l FAT16
l FAT32
The W-600 Series supports a maximum of four devices. To ensure higher reliability, only connect one USB powered
device. The other three devices should use an external power source.
NAS Device Setup
Setting up a NAS device involves the following step:
l Connecting the physical device to the USB port in the controller
l Mounting the device on the controller
l Creating a share—To use the mounted NAS device, you must create a share on the NAS device.
l Associating the share with a filesystem path
Power on the NAS device after you connect the NAS device to the W-600 Series controller’s USB port. Verify that
the usb disk is detected (show usb command).
(host) #show usb
USB Device Table
----------------
DellPowerConnectW-SeriesArubaOS6.2 | User Guide W-600Series Controllers | 739