Filter
Top Products
391 | WirelessIntrusionPrevention DellPowerConnectW-SeriesArubaOS6.2 | User Guide
The default value is “all”, which is consistent with the prior behavior. This setting is ignored in the case of a dual
radio AP.
There are four parameters that will control the age out of devices in the AM module.
ids general-profile <name>
ap-inactivity-timeout
sta-inactivity-timeout
ap-max-unseen-timeout
sta-max-unseen-timeout
The inactivity timeout is the number of times the device was not “seen” when the channel was scanned. The unseen
timeout is the time, in seconds, since the device was last “seen.”
The show ap monitor scan-info/channel commands provide details of the channel types, dwell times, and the
channel visit sequence.
(host) # show ap monitor scan-info ap-name rb-121
WIF Scanning State: wifi0
--------------------------
Parameter Value
--------- -----
Scan Mode all-reg-domain
Scan Channel yes
Disable Scanning no
Current Channel 36-
Current Scan Channel 36-
Current Channel Index 1
Current Scan Start Milli Tick 351757100
Current Dwell Time 600
Current Scan Type active
Scan-Type-Info
---------------
Info-Type Active Reg-domain All-reg-domain Rare DOS
--------- ------ ---------- -------------- ---- ---
Dwell Times 600 250 100 100 600
Last Scan Channel 36- 116- 0 0 0
(host) #show ap monitor channel ap-name rb-121 36
Aggregate Stats
---------------
retry low-speed non-unicast frag bwidth phy-err mac-err noise
----- --------- ----------- ---- ------ ------- ------- -----
0 0 0 0 1 0 9 90
Scanning Stats
---------------
scans-attempted assign-time(ms) last-visit-time monitored-time reside-time(ms) dos-scans
flags
--------------- --------------- --------------- -------------- --------------- ---------
-----
42702 25620500 402424 56245 0
0 DVACLU
Channel Flags: D: Default, V: Valid, A: AP Present, C: Reg Domain Channel,
O: DOS Channel, Z: Rare Channel
T: Valid 20MHZ Channel, F: Valid 40MHz Channel,
L: Scan 40MHz Channel (lower), U: Scan 40MHz channel (upper)
R: Radar detected in last 30 min, X: DFS required