Dell 6.2 Server User Manual


 
545 | Remote AccessPoints DellPowerConnectW-SeriesArubaOS6.2 | User Guide
---------------
Parameter Value
--------- -----
Manufacturer Pantech,
Product PANTECH
Serial Number
Driver ptuml_cdc_ether
Vendor ID 106c
Product ID 3718
USB Modem State Active
USB Uplink RSSI(in dBm) -73
Supported Network Services CDMA GSM LTE
Firmware Version L0290VWB522F.242
ESN Number 990000472325325
Current Network Service 4G-LTE
Configuring W-IAP3WN Access Points
This release of ArubaOS introduces support for W-IAP3WN and W-IAP3WNP access points (APs). The Dell W-
IAP3WN and W-IAP3WNP are single-radio, single-band wireless APs that support the IEEE 802.11n standard for
high-performance WLAN. These APs use MIMO (Multiple-in, Multiple-out) technology and other high-throughput
mode techniques to deliver high-performance, 802.11n 2.4 GHz functionality while simultaneously supporting
existing 802.11 b/g wireless services.
See the
Dell PowerConnect W-Series W-IAP3WN Installation Guide
for more information.
NOTE: These access points require Dell Instant 3.0 or later to operate as an Instant AP or ArubaOS 6.1.4.0 or later to operate as a
Remote AP.
The Power Sourcing Equipment (PSE) functionality is available only for W-IAP3WNP APs, as the PoE itself
provides the PSE functionality for W-IAP3WN APs. You can use the WebUI or CLI to enable or disable the PSE
functionality on the W-IAP3WNP APs.
Using the WebUI
1. Navigate to the Configuration > Advanced Services > All Profiles page.
2. Select the AP tab and then select the AP Ethernet Link profile tab.
3. Select the default tab .
4. Select the Power over Ethernet checkbox.
5. Click Apply.Support for W-IAP3WN and W-IAP3WNP access points (APs)
Using the CLI
l To enable, enter:
(host)(config) #ap enet-link-profile <name>
poe
l To disable, enter:
(host)(config) #ap enet-link-profile <name>
no poe
Use the following command to view the PoE port status on an AP:
(host) #show ap enet-link-profile default
AP Ethernet Link profile "default"
----------------------------------
Parameter Value
--------- -----