Filter
Top Products
3. Select the AAA Profiles tab.
a. In the AAA Profiles Summary, click Add to add a new profile.
b. Enter aaa_dot1x, then click Add.
a. Select the profile name you just added.
b. For MAC Auth Default Role, select computer.
c. For 802.1x Authentication Default Role, select faculty.
d. Click Apply.
4. In the Profiles list (under the aaa_dot1x profile), select 802.1x Authentication Profile.
a. From the drop-down menu, select the dot1x 802.1x authentication profile you configured previously.
b. Click Apply.
5. In the Profiles list (under the aaa_dot1x profile), select 802.1x Authentication Server Group.
a. From the drop-down menu, select the IAS server group you created previously.
b. Click Apply.
In the CLI
(host)(config) #aaa authentication dot1x dot1x
machine-authentication enable
machine-authentication machine-default-role computer
machine-authentication user-default-role guest
(host)(config) #aaa profile aaa_dot1x
d>ot1x-default-role faculty
mac-default-role computer
authentication-dot1x dot1x
d>ot1x-server-group IAS
Configuring VLANs
In this example, wireless clients are assigned to either VLAN 60 or 61 while guest users are assigned to VLAN 63.
VLANs 60 and 61 split users into smaller IP subnetworks, improving performance by decreasing broadcast traffic.
The VLANs are internal to the Dell controller only and do not extend into other parts of the wired network. The
clients’ default gateway is the Dell controller, which routes traffic out to the 10.1.1.0 subnetwork.
You configure the VLANs, assign IP addresses to each VLAN, and establish the “helper address” to which client
DHCP requests are forwarded.
In the WebUI
1. Navigate to the Configuration > Network > VLANs page. Click Add to add VLAN 60.
a. For VLAN ID, enter 60.
b. Click Apply.
c. Repeat steps A and B to add VLANs 61 and 63.
2. To configure IP parameters for the VLANs, navigate to the Configuration > Network > IP > IPInterfaces
page.
a. Click Edit for VLAN 60.
b. For IP Address, enter 10.1.60.1.
c. For Net Mask, enter 255.255.255.0.
d. Under DHCP Helper Address, click Add. Enter 10.1.1.25 and click Add.
e. Click Apply.
DellPowerConnectW-SeriesArubaOS6.2 | User Guide 802.1XAuthentication | 210