Filter
Top Products
531 | Remote AccessPoints DellPowerConnectW-SeriesArubaOS6.2 | User Guide
user-role <role>
session-acl <policy>
Using the CLI to configure the AAA profile
aaa profile <name>
initial-role <role>
You can define other parameters as needed.
Defining the Backup Configuration in the CLI
wlan ssid-profile <profile>
essid <name>
opmode <method>
wpa-passphrase <string> (if necessary)
wlan virtual-ap <name>
ssid-profile <profile>
vlan <vlan>
forward-mode bridge
aaa-profile <name>
rap-operation {always|backup}
ap system-profile <name>
lms-ip <ipaddr>
master-ip <ipaddr>
rap-dhcp-default-router <ipaddr>
rap-dhcp-dns-server <ipaddr>
rap-dhcp-lease <days>
rap-dhcp-pool-end <ipaddr>
rap-dhacp-pool-netmask <netmask>
rap-dhcp-pool-start <ipaddr>
rap-dhcp-server-id <ipaddr>
rap-dhcp-server-vlan <vlan>
ap-group <name>
virtual-ap <name>
ap-system-profile <name>
or
ap-name <name>
virtual-ap <name>
ap-system-profile <name>
Specifying the DNS Controller Setting
In addition to specifying IP addresses for Dell controllers, you can also specify the master DNS name for the
controller when provisioning the remote AP. The name must be resolved to an IP address when attempting to setup
the IPSec tunnel. For information on how to configure a host name entry on the DNS server, refer to the vendor
documentation for your server. Dell recommends using a maximum of 8 IP addresses to resolve a controller name.
If the remote AP gets multiple IP addresses responding to a host name lookup, the remote AP can use one of them
to establish a connection to the controller. For more detailed information, see the next section "Backup Controller
List " on page 532.
Specifying the name also lets you move or change remote AP concentrators without reprovisioning your APs. For
example, in a DNS load-balancing model, the host name resolves to a different IP address depending on the location
of the user. This allows the remote AP to contact the controller to which it is geographically closest.