Filter
Top Products
Parameter Description
Shut Down Disable the wired AP port.
Remote AP Backup If enabled, the port of Remote-AP is up for the local connectivity and
troubleshooting when the controller is not reachable and no firewall
policies will be applied.
If disabled, the port would be up for the bridge mode when controller is not
reachable, and retains the previous bridge wired port configuration (if the
configuration is applied and persistent).
For split and tunnel modes, the ports would be shutdown when the controller is not
reachable.
Time to wait for authentication to
succeed
Authentication timeout value, in seconds, for devices connecting the AP’s wired port.
The supported range is 1-65535 seconds, and the default value is 20 seconds.
Table 278:
Ethernet Interface Port/ Wired AP Port Configuration Parameters
3. Each Ethernet Interface Port/AP Wired Port Configuration profile is automatically associated to the wired AP
profile Default. To assign a new wired AP profile to the AP wired port:
a. Click the wired AP profile directly under the Ethernet port profile you are editing.
b. In the Profile Details window, click the Wired AP Profile drop-down list and select a new Wired AP profile.
4. A new AP wired profile is automatically associated to the Ethernet Interface Link profile Default. To assign a
new Ethernet Interface Link profile to the AP wired port:
a. Click the Ethernet Interface Link profile directly under the Ethernet port profile you are editing.
b. In the Profile Details window, click the Ethernet Interface Link drop-down list and select a new Ethernet
Interface Link profile.
5. By default, there is no AAA profile associated with an AP wired port profile. To assign an AAA profile to the AP
wired port:
a. Click the AAA profile directly under the Ethernet port profile you are editing.
b. In the Profile Details window, click the AAA Profile drop-down list and select an AAA profile.
6. Click Apply to save your settings.
In the CLI
To create a new Ethernet Port/Wired AP Port profile, access the command-line interface in Config mode and issue
the following command.
ap wired-port-profile <profile>
aaa-profile <profile>
authentication-timeout <seconds>
enet-link-profile <profile>
rap-backup
shutdown
wired-ap-profile <profile>
To associate an existing Ethernet Port/Wired AP Port profile to a specific interface on an AP or group of APs,
access the command-line interface in Config mode and issue the following command.
ap-group <group>
enet0-port-profile <profile>
enet1-port-profile <profile>
enet2-port-profile <profile>
enet3-port-profile <profile>
enet4-port-profile <profile>
DellPowerConnectW-SeriesArubaOS6.2 | User Guide AdvancedSecurity | 676