Filter
Top Products
334 | VirtualAPs DellPowerConnectW-SeriesArubaOS6.2 | User Guide
To create a new 802.11k Profile, click the 802.11K Profile drop-down list and select New. Enter a new 802.11k
profile name in the field to the right of the drop-down list.
4. Configure your 802.11k radio settings. Table 90 outlines the parameters you can configure in the 802.11k profile.
Click Apply to save your settings.
Parameter Description
Advertise 802.11K Capability Select this option to allow Virtual APs using this profile to advertise
802.11K capability.
Default: Disabled
Forcefully disassociate on-hook voice clients Select this option to allow the AP to forcefully disassociate
on-hook
voice clients (clients that are not on a call) after period of inactivity.
Without the forced disassociation feature, if an AP has reached its call
admission control limits and an on-hook voice client wants to start a
new call, that client may be denied. If forced disassociation is enabled,
those clients can associate to a neighboring AP that can fulfill their
QoS requirements.
Default: Disabled
Measurement Mode for Beacon Reports Click the Measurement Mode for Beacon Reports drop-down list and
specify one of the following measurement modes:
l active—Enables active beacon measurement mode. In this mode,
the client sends a probe request to the broadcast destination
address on all supported channels, sets a measurement duration
timer, and, at the end of the measurement duration, compiles all
received beacons or probe response with the requested SSID and
BSSID into a measurement report.
l beacon-table—Enables beacon-table beacon measurement mode.
In this mode, the client measures beacons and returns a report with
stored beacon information for any supported channel with the
requested SSID and BSSID. The client does not perform any
additional measurements.
l passive—Enables passive beacon measurement mode. In this
mode, the client sets a measurement duration timer, and, at the end
of the measurement duration, compiles all received beacons or
probe response with the requested SSID and BSSID into a
measurement report.
NOTE: If a station doesn't support the selected measurement mode, it
returns a Beacon Measurement Report with the Incapable bit set in the
Measurement Report Mode field.
Default Mode: beacon-table
Channel for Beacon Requests in 'A' band This value is sent in the 'Channel' field of the beacon requests on the
'A' radio. You can specify values in the range 34 to 165. The default
value is 36.
Channel for Beacon Requests in 'BG' band This value is sent in the 'Channel' field of the Beacon Requests on the
'BG' radio. You can specify values in the range 1 to 14. The default
value is 1.
Channel for AP Channel Reports in 'A' band This value is sent in the 'Channel' field of the AP channel reports on the
'A' radio. You can specify values in the range 34 to 165. The default
value is 36.
Channel for AP Channel Reports in 'BG' band This value is sent in the 'Channel' field of the AP channel reports on the
'BG' radio. You can specify values in the range 1 to 14. The default
Table 90:
802.11k Profile Parameters