Filter
Top Products
Parameter Description
Accounting Port Accounting port on the server
Default: 1813
Retransmits Maximum number of retries sent to the server by the controller before the server is marked as down.
Default: 3
Timeout Maximum time, in seconds, that the controller waits before timing out the request and resending it.
Default: 5 seconds
NAS ID Network Access Server (NAS) identifier to use in RADIUS packets.
Default: N/A
NAS IP NAS IP address to send in RADIUS packets.
You can configure a “global” NAS IP address that the controller uses for communications with all
RADIUS servers. If you do not configure a server-specific NAS IP, the global NAS IP is used. To set
the global NAS IP in the WebUI, navigate to the Configuration > Security > Authentication >
Advanced page. To set the global NAS IP in the CLI, enter the ip radius nas-ip
ipaddr
command.
Default: N/A
Source Interface Enter a VLAN number ID.
Allows you to use source IP addresses to differentiate RADIUS requests.
Associates a VLAN interface with the RADIUS server to allow the server-specific source interface to
override the global configuration.
l If you associate a Source Interface (by entering a VLAN number) with a configured server, then
the source IP address of the packet is that interface’s IP address.
l If you do not associate the Source Interface with a configured server (leave the field blank), the
IP address of the global Source Interface is used.
Use MD5 Use MD5 hash of cleartext password.
Default: disabled
Mode Enables or disables the server.
Default: enabled
Using the WebUI
1. Navigate to the Configuration > Security > Authentication > Servers page.
2. Select Radius Server to display the Radius Server List.
3. To configure a RADIUS server, enter the name for the server and click Add.
4. Select the name to configure server parameters. Enter parameters as described in Table 48. Select the Mode
checkbox to activate the authentication server.
5. Click Apply to apply the configuration.
NOTE: The configuration does not take effect until you perform this step.
Using the CLI
(host)(config) #aaa authentication-server radius <name>
host <ipaddr>
key <key>
enable
DellPowerConnectW-SeriesArubaOS6.2 | User Guide Authentication Servers | 170