Filter
Top Products
Hardware Installation
2−52 CM 4000 Installation and Operating Manual
Unbalanced split panels can be configured to control from 1 to 31 outputs, with keys not used for outputs available to control
inputs. For example, if 10 buttons are assigned to outputs then 54 buttons are available for inputs.
Except for unbalanced split and CP 3864L configurations, control of additional inputs/outputs is possible using adjacent CP
3864 or CP 3832 panels (page 2−53); as another alternative, the CP 3864 can be operated in connection with an adjacent CP
3810 Expansion Panel (see page 2−54).
Hardware Installation
Installation of this panel is shown on page 2−37.
If desired, the panel hardware can be tested, and window/button brightness adjusted, without being connected to the controller
board (such as a CM 4000). For more information, see Diagnostics Mode on page 6−112.
Software Configuration
The panel uses an eight−character CP Level Set of type “3800” (page 5−58).
MPK table entries will depend on the application (see page 5−107).
Sources are defined in a CP Input Set of type “cp3832” (page 5−62). Destinations are defined in a CP Output Set of type
“cp3832” (page 5−78).
Before the panel can be used, these sets must be compiled, and the appropriate configuration set made active using the Control
Center (page 5−13).
For CP 3864 operating instructions, see page 6−26.
For CP 3864L operating instructions, see page 6−117.