Filter
Top Products
Control Panel Operation
CP 3800
6−60 CM 4000 Installation and Operating Manual
SEQ
SEQUENCE MODE (CONT’D)
Viewing Sequence Definitions
To view sequence definitions, place the panel in the Define Sequence mode as defined above. Then select an existing se-
quence. The following display will be shown:
1 Definition of <TST_SQ17>, Entry:01, Destination=PROCTN1, Source=Test−17
TST_SQ17 TST_SQ17 TST_SQ17 TST_SQ17 TST_SQ17 TST_SQ17 TST_SQ17 TST_SQ17
Figure 6−93. Example Viewing Sequence Definition − Sequence Entry 1.
Page numbers are included if more than eight levels are defined for a sequence. Special audio modes are indicated with a
blinking ‘R’ for Reverse and ‘M’ for Mix. If more than one entry exists, the TAKE button will turn red, allowing the user
to display the next entry. To exit this mode, the user will press either the red SEQUENCE or CLEAR buttons. This will return
the operator to the Define Sequence Mode. The CLEAR button turns red when the last sequence entry is reached.
Erasing a Sequence
Sequences may be erased if no longer needed or to make room for new definitions from the Define Sequences Home mode.
Enter define mode by pressing the SEQ button (see above for menu display). Selecting CLEAR at this point allows erasing
user defined sequences. The display will indicate this mode and prompt for a button assignment (valid soft key locations will
illuminate in green):
1 Erasing Sequence − Use Up/Down Buttons And Soft Key To Select Position
BLACKSEQ BARSSEQ SEQ_A SEQ_B USRSEQ05 USRSEQ06 USRSEQ07 USRSEQ08
Figure 6−94. Example Erasing Sequence Menu.
The user may scroll pages as appropriate and select the desired button position to be erased. Upon selection of a valid position
the user will be prompted for confirmation while the selected sequence name blinks on the display.
1 Erasing Sequence − Select TAKE To Confirm Or CLEAR To Cancel
BLACKSEQ BARSSEQ SEQ_A SEQ_B USRSEQ05 USRSEQ06 USRSEQ07 USRSEQ08
Figure 6−95. Example Erasing Sequence Menu − Seventh Button Position Clear Confirmation.
From this menu the operator can confirm the desired clear operation by pressing TAKE or select CLEAR to return to the Home
Defining Sequence menu to try again. Pressing TAKE will also return the panel to Sequence Selection mode; an additional
press of the SEQ and CLEAR buttons are required for each completed clear.
As with Sequence Definitions, clears may also be aborted at any time by selecting the SEQ button when it is red or blinking
red. A brief message will appear on the top line stating “SEQUENCE CLEAR ABORTED” and the panel will return to the
Sequence selection menu and the SEQ button will illuminate in green.