Filter
Top Products
Control Panel Operation
CP 3010
6−24 CM 4000 Installation and Operating Manual
CP 3010 Expansion Panel Operation
The CP 3010 can be used as a companion to the CP 3000 Switcher Control Panel (described immediately below) or to the
MC 3000 Machine Control Panel (see page 6−131).
CP 3010 AS COMPANION TO CP 3000 SWITCHER CONTROL PANEL
For multi−bus control the desired source can be selected on the CP 3000; the CP 3010 would then display the names of up
to eight destinations, beneath which are the corresponding TAKE keys; one of these would be pressed to complete the switch.
20 pages of eight destinations each can be scrolled to display up to 160 possible destinations. To return to page 1, press the
UP and DOWN arrows at the same time.
TAKE
−−−−−−
SEL
TAKE
−−−−−−
SEL
TAKE
−−−−−−
SEL
TAKE
−−−−−−
SEL
TAKE
−−−−−−
SEL
TAKE
−−−−−−
SEL
TAKE
−−−−−−
SEL
TAKE
−−−−−−
SEL
>>>>>>>>
Figure 6−27. CP 3010 Expansion panel.
∧
∨
Status
Output
CAM1
MON1
Scroll up
Scroll down
CAM3
MON3
CAM2
MON2
VTR1
VTR2
Dynamic Assignment of Outputs to the TAKE Keys
The process of assigning outputs to the expansion panel is the same as assigning the output to be controlled by the CP 3000,
except that TAKE is pressed on the expansion panel rather than on the CP 3000:
1. On the CP 3000, press MENU, then OUT. Then select the category and number of an output.
2. On the expansion panel, scroll to the desired page and press the appropriate TAKE key.
Deleting an Output on TAKE Key
To delete an output that has been dynamically assigned to the expansion panel, use the CP 3000 to select an output that is not
defined and press the appropriate TAKE key on the expansion panel.