Filter
Top Products
Configuration Swap
H−4 CM 4000 Installation and Operating Manual
Thomson Jupiter Configuration Set : Xpress−1 Page: 00
03/07/03 System Command Page 20:10:34
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
BOARD | Current Configuration | Previous Configuration..
−−−−−−−−−−+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
CM−Board |Xpress−1−Fri Mar 07 10:28:16 2003|Xpress−2−Fri Mar 07 09:35:16 2003
CM−Board-R|Xpress−1−Fri Mar 07 10:28:16 2003|Xpress−2−Fri Mar 07 09:35:16 2003
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
Press <SELECT> then <UP> or <DOWN> to Highlight, <Select> to Choose
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
Exit Swap Configuration Clear PMEM Reboot Local Reboot Global
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
20. Press and release the SELECT button, which will highlight Exit.
21. Press and release the DOWN button until Swap Configuration is highlighted.
22. Press and release the SELECT button, which will Swap Configurations and reboot.
23. Once the system is rebooted and active again, verify the system is operating correctly.
24. While pressing and holding the NEXT button, press and release the UP button on a Jupiter Xpress board configured
for VGA to enter the System Command Page.
25. Verify that the Current Configuration for each board is now Xpress−1 and the Previous Configuration is now
Xpress−2.
26. Press and release the SELECT button, which will highlight Exit.
27. Press and release the SELECT button a second time to Exit the System Command Page.
Note: If Swap Configurations is selected and all the Jupiter XPress boards in the system do not have the same
Current Configuration (Xpress−1 on all boards) and the same Previous Configuration (Xpress−2 on all
boards) then the configuration swap will be aborted.