Filter
Top Products
Configurator
MPK Devices
5−112 CM 4000 Installation and Operating Manual
SETTING UP A SWITCHER CONTROL PANEL FOR FULL−MATRIX, MULTI−BUS, OR
SINGLE−BUS CONTROL
The output(s) that can be controlled by a control panel will depend on the CP Output Set entry for that panel on the MPK
Devices menu:
1. On the top of the Jupiter Configurator window (page 5−2), check to see whether the configuration set you want to
change is selected for editing.
In most cases, you will want to modify the set that is currently active; if so, you may want to copy the active set and
select the copy for editing. For more information, please see Copying a Configuration Set for Editing on page 5−10.
2. Click on “Jupiter > MPK devices.” This will open a table similar to that shown on page 5−107, which is a list of all control
panels in the system. The column of interest is labelled “Out Set.”
3. Click on the Output Set field you want to change.
4. In most cases, you’ll want to enter the name of the desired CP Output Set (for full/multi−bus operation), or select the
name of a single switcher output (for single bus operation).
Creation of Output Sets was described on page 5−78. The source of the output names is the Switcher Output table (page
5−55).
You may wish to review the “Out Set” discussion on page 5−110 for special entries required for some control panel ap-
plications.
5. After saving your changes, validate, compile and activate the configuration set. (See page 5−13 if you need more in-
formation.)