Filter
Top Products
Control Panel Operation
CP 3000
6−7CM 4000 Installation and Operating Manual
CP 3000 Switcher Control Panel
Note: For a general discussion of the CP 3000, please see page 2−42; for a short tutorial on basic operations only,
see Appendix J.
The top row of the display shows output status for four levels. Using the CLEAR key, the bottom row can be toggled between
the first page of input override selections and the name of the current output (see Figure 6−7). Input overrides permit single
button input selection, eliminating the need to use the category and selection entry keypad for commonly used inputs.
To change the output is being controlled by the panel, please see Display/change Output on page 6−20.
Figure 6−7. Push CLR to toggle display.
VTR
1
CG
2
NET
3
SAT
EJVCR
4
CAM
5
REM
6
FILM
7
PTCH
8
STU
9
FS
AUX TEST
0
MISC SS
A
B
C
D
TAKECHOPLOCKPROT
F4F3F2F1
MORECLRMENULEV
VTR1 VT1L VT1R VT1T
BLK BARS TONE SLNC
VTR1 VT1L VT1R VT1T
CURRENT OUTPUT=VTR2
Overrides
Status
Output
Status
OVERRIDE INPUT SELECTION
Override input selections are made by pressing a Function button below the desired mnemonic. The operator can see other
possible selections by pressing MORE. After the operator makes an override selection, the mnemonic and the levels defined
for the selected input are displayed in the prompt window. The operator then presses TAKE to send the command to the
switcher. The operator can exit the entry mode by pressing CLEAR and the panel returns to the mode it was in before the
override was selected.
If entry of a password is requested, please see Passwords on page 6−22.
For information about programming overrides, see page 6−21.