Filter
Top Products
Configurator
CP Input Set
5−69CM 4000 Installation and Operating Manual
b. Specify the desired Entry (unit) number. This can be done by clicking on the desired “Entry” field and typing in
the number. Press ENTER.
Guidelines for using the editor are found on page 5−3.
Note: For an input that is heavily used, an entry number of zero can be specified to help speed up control
panel operation. For example, by assigning color bars as “Test 0,” the mnemonic for color bars will ap-
pear immediately on the control panels whenever “Test” is selected; the operator can then complete the
switch by pressing Take. However, for this to work properly the zero entry must appear in this table
before all other entries for that category; for example, “Test 0” must appear before “Test 1,” “Test 2,”
etc.
c. Select the Input name.
The source for the input names is the Switcher Input table (page 5−48).
d. Check the Auto Mnemonic box or enter the desired Mnemonic.
The Auto Mnemonic function can be used to enter a control panel mnemonic automatically based on the Name
given to the input. In cases where the input Name is more than four characters long, the mnemonic will be truncated
to the first four characters.
If an input Name is changed on the Switcher Input table and Auto Mnemonic is enabled, the mnemonic will change
to the new name automatically.
Note: if you use the Auto Mnemonic feature, it will not work if you go back to a version of the Jupiter
editor prior to 6.2.1.
CP 3000 panel mnemonics are limited to four characters.
When finished, skip to Step 15.
10. CP 320, CP 328, CP 3824, CP 3830
a. Enter the desired Category. This can be done by double−clicking on the appropriate field in the Category column;
this will open a pull−down menu of categories. Click on a category and press ENTER.
The 16−category factory default set used for the CP 3808 panel is as follows:
Default sets may vary —
confirm by creating a new set!
VTR CAM SAT EJ
VCR NET REM FILM
Studio MISC AUX FS
CGEN TEST PTCH STILL
The 16−category factory default set used for CP 320 and CP 328 panels is as follows:
VTR CG NET VCR
CAM AUX EJ SS
REM FILM PTCH STU
TEST SAT FS MISC