Filter
Top Products
Software Control Panel Suite
7−23CM 4000 Installation and Operating Manual
Switching Multiple Destinations to the Same Input (Dub Switching)
1. Select the appropriate Destination buttons.
Additional Destination Entries buttons, if available, are accessed by using the scroll buttons. The label of the se-
lected buttons will change from black to yellow and the entry name of the last destination selected will be written
in the Destination display. The Status display will be rewritten to provide current source status.
To cancel a single output selection, select that button again.
To cancel all Destination Entries select Clear.
2. Select the desired Source Category button.
The Source Entries section will be rewritten to display up to 12 source buttons.
3. Select the desired Source Entry button.
The source entry will be entered into the Source Preset display.
4. Select Take to execute the switch.
The Status display will change to the new source indicating the switch was made. The Preset display will change
to the previously selected source. Flip−flop switching between the old and new source will be accomplished by
selecting the Take button again.
Paths Full / Protected / Locked / Excluded Messages − see page 7−8.
Using the Hold Button
When Hold is pressed, the button label will change from white to red indicating that the selections made in the Destination
Entries section cannot be inadvertently changed.
Select the Hold button again to toggle the function off. The Hold button label will change from red to white indicating
the Hold function has been disabled and the selections in the Destinations Entries section can be modified.