Filter
Top Products
Control Panel Operation
CP 3800
6−31CM 4000 Installation and Operating Manual
MULTIPLE DESTINATION MODE
This mode, sometimes referred to as “multi−bus” or “full−matrix control” mode, is in effect when none of the “mode” buttons
are illuminated. This mode displays the top level status for eight destinations.
Note: If no destinations are defined for the panel, upon powering up the panel will go into the “adding destination
assignment” mode as explained on page 6−34. Follow the steps outlined to define at least one destination to one
button.
The first line contains the status of those eight destinations (defined name in the CP Input set for the selected source) plus
a page number in the upper left hand corner. The second line of the display will show up to eight destinations.
Figure 6−35. Example Multiple Destination Display Page − Home
VTR_01 VTR_02 VTR_03 ENGNRING STUDIO_A STUDIO_D MONITR45 MONITR46
Camera_1 Camera_2 Studio_a Clr_Bars VTR_02 NetworkA NetworkABlack
F1 F2 F3 F4 F5 F6 F7 F8
1
Output
Status
Page
From this page you can:
• Scroll to other pages
• Select destination(s) and make a source change
• Add or change a destination assignment
• Erase a destination assignment
You can also change Protect/Lock status, level selections, and audio modes once a destination(s) has been selected. Those
operations are described in the appropriate separate sections in this document.
Scrolling to Other Pages
Scrolling to other pages is achieved with the Up/Down Arrows in the Menu Control Group. A maximum of 20 pages are acces-
sible, each page numbered in the upper left.