Filter
Top Products
Control Panel Operation
CP 3800
6−40 CM 4000 Installation and Operating Manual
DEST
SINGLE DESTINATION MODE (CONT’D)
Making a Switch
1. Select a category.
To select a new source, the user enters Source Assignment Mode by selecting any of the green illuminated Category
buttons. The display will update as shown below and if prompting is enabled (page 6−51), the available source number
buttons will illuminate in red.
Destination = PRODCTN4 Current Source = VTR_0001
Category = Vid_Tape Number = ??? New Source = ????????
Figure 6−51. Example Single Destination Source Assignment Display Page − Category Selected.
2. Select a number.
Numbers may be selected as indicated by valid red illumination
Destination = PRODCTN4 Current Source = VTR_0001
Category = Vid_Tape Number = 1 New Source = VTR_0001
Figure 6−52. Example Single Destination Source Assignment Display Page − Category & One Digit Selected.
Destination = PRODCTN4 Current Source = VTR_0001
Category = Vid_Tape Number = 12 New Source = VTR_0012
Figure 6−53. Example Single Destination Source Assignment Display Page − Category & Two Digits Selected.
3. Press TAKE.
The source assignment operation may be completed using the TAKE button any time a valid selection has been made.
This will be indicated by the presence of a source name in the display after the display of “New Source =” and the fact
that the TAKE button will be illuminated.
Pressing CLEAR at any time during the entry process will return the panel to the Destination Assignment No Selections
Made Mode. Selection of CLEAR at that state or reselecting the red DEST button at any time will cancel the operation
and return the panel to Single Destination Mode Home State.
At any time prior to selecting TAKE, levels and audio modes may also be selected as described in the appropriate section
below.