Filter
Top Products
Control Panel Operation
CP 3800
6−45CM 4000 Installation and Operating Manual
MENU
MENU MODE
This mode is in effect when the “MENU” button is illuminated.
Menu mode is used to access less frequently needed functions, run diagnostics, and to configure the panel. Select the MENU
button to enter this mode. That button will illuminate in green and the panel will present the following display:
Menu Page − Select Desired Soft Key
VTR CNTL DIAGNOSTIC CHOP CONFIG PASSWORD
Figure 6−58. Top Level Menu Page.
From this menu any of the five choices presented may be selected on the appropriate green illuminated soft keys.
VTR Control
When this soft key is selected, the panel goes into one of two modes, depending upon whether it was in single or multi destina-
tion mode prior to the selection of the menu button. The MENU button will change to red and remain illuminated.
If no machine control has been defined for the panel, “VTR CNTL” will not be selectable and the following will be displayed:
Machine Control NOT Defined For This Panel
VTR CNTL DIAGNOSTIC CHOP CONFIG PASSWORD
Figure 6−59.
Single Destination VTR Control
When the CP 3800A has been configured for machine control (using the Machine Control table, page 5−139) and if a valid
controlled VTR source has been switched to the destination, the panel will present the following menu display:
Destination = VTR_0001 Source = VTR_0002
PLAY STOP READY CUE MARK REWIND F FWD RECORD
Figure 6−60. Example Single Destination Machine Control Page.
From this page, any of the displayed machine control functions can be selected. “Record” is selected by pressing both the
PLAY and RECORD soft keys. All other commands are accessed by single button selections.